Fujitsu Siemens Computers BS2000/OSD - Manual (Page 92)

92 U25339-J-Z126-1-7600
Problems with the S130 Troubleshooting
8.1.1 Displays in the case of a hardware error
The S130 informs you of hardware errors in the following manner:
● On the S130 control panel
If the yellow CHECK light illuminates, there may be a hardware error.
At the same time, the FLAG code appears on the LCD display. This can indicate an error
in the service processor or a machine error.
● On the screen of the SKP console in the SVPST0 window
On the SKP console, displays in line 24 in the SVPST0 window of the SVP frame can
indicate a hardware error. Evaluation of the FLAG code is carried out by the service
department. The following diagram shows the format of the error display:
Figure 44: FLAG code display in line 24 of the SVPST0 screen
The FLAG code FF . . . FF can have different meanings and can therefore require
different measures:
– A WRITE-CONSOL message is displayed. It can be deleted with the key. This
does not delete the FLAG code display.
– A warning is issued, e.g. if the room temperature is too high. The cause of the error
must be eradicated. System operation can continue in the meantime.
– An error has occurred in the S130 or on the interface to the peripheral devices which
was automatically corrected by the hardware. In this case, system operation can
also be continued.
– An error has occurred which does not permit system operation to be continued.
In the last case, you can take the following measures:
If the system is down, execute an IMPL. If this does not solve the problem, contact the
service department and discuss what steps should be taken.
LTG TAST
FLAG CODE = FFFFFFFF FFFFFFFF
F3