Setting operating mode via program load fram – Fujitsu Siemens Computers BS2000/OSD User Manual
Page 87
U25339-J-Z126-1-7600
87
Standard processing in SVP mode
Setting operating mode
6.5.6
Setting operating mode via PROGRAM LOAD FRAME: DETAIL-2
The operating mode can be reset using the PROGRAM LOAD FRAME: DETAIL-2. This
selects the appropriate firmware for running BS2000 or VM2000.
The following are specified in the example below:
●
VM2000 operating mode
●
executing IPL after reloading the firmware
Conditions
You must be in the PROGRAM LOAD FRAME: DETAIL-1 screen.
Invoke PROGRAM LOAD FRAME: DETAIL-2 screen
Ê
Press the
key.
The PROGRAM LOAD FRAME: DETAIL-2 screen appears:
Figure 43: PROGRAM LOAD FRAME: DETAIL-2 screen
VM MODE =>
Enter
3
for VM2000 operation.
EXA MODE =>
Always enter
1
.
IPL EXECUTION =>
Enter
1
.
P9
----- PROGRAM LOAD FRAME: DETAIL-2 ----- E02L01F
-VM MODE- -EXA MODE- -IPL EXECUTION-
==> 3 ==> 1 ==> 1
*1 NATIVE >*1 ENABLE >*1 ENABLE
*2 EMOS *2 DISABLE *2 DISABLE
>*3 AVM/EX
*ENTER EXECUTE
*PF3 GO TO BASIC FRAME
*PF9 GO TO DETAIL-1
CL-0 CPU-0 CHP-0 RUN
M
FLAG CODE = F6C0C100 00000F00
LTG TAST