Fujitsu Siemens Computers BS2000/OSD - Manual (Page 43)

U25339-J-Z126-1-7600 43
Standard processing in SVP mode Using frames
Overview of the SVP function keys
The following overview shows the keys and their functions as valid for most SVP frames. In
some SVP frames keys can have another function. This is then shown in the corresponding
SVP frame description.
Some of the keys shown here only have a function in CE mode (see information below) and
are used exclusively by the service department.
CE=Customer Engineer; the CE mode on the S130 can only be switched on and off
by the service department using a key switch on the inside of the maintenance
panel.
The designations of the SVP function keys are different on the screen from those on the
EMDS keyboard mask. Column 1 of the following table contains the designation of the SVP
function keys on the screen (example: PF4), column 2 contains the corresponding keys on
the EMDS keyboard mask.
PF . . P . . Name Function
PF1 Help Help functions
PF 2 Index Only in CE mode : switches to the index frame
PF 3 Return Switches to the previous frame.
PF 4 Frame-specific function is executed.
PF 5 Frame-specific function is executed.
PF 6 Cancel/Erase Input Command or input is erased.
PF 7 Page up The previous screen contents are displayed.
PF 8 Page down The next screen contents are displayed.
PF 9 Frame-specific function is executed.
PF 10 Frame-specific function is executed.
PF 11 Frame-specific function is executed.
PF 12 Frame-specific function is executed.
PF 13 Recall Previous SVP commands are displayed in the
command line; they can then be executed again with
changed operands.
PF 14 Frame-specific function is executed.
PF 15 Frame-specific function is executed.
PF 16 Change CPU Selects the CPU for which the following commands
are valid. This CPU is then logically connected to the
SVP.
PF 17 not assigned.
i
P1
P2
P3
P4
P5
P6
P7
P8
P9
P10
P11
P12
P13
P14
P15
P16
P17