GCC Printers Elite XL - Manual (Page 178)

Upgrading the printer’s memory C-5
9. Remove SIMMs (if applicable).
If your printer has SIMMS in both connectors, and you are only replacing one
of them, remove the SIMM from the second connector (see previous illustra-
tion).
a. Place your index fingers under the back edge of the SIMM.
b. With your thumbs, slowly push the two retaining clips outward until
the clips clear the top surface of the SIMM; the SIMM will come free
and flip upwards.
c. Grasping the SIMM between your thumbs and index fingers,
pull the SIMM out towards you.
10. Insert the SIMM(s).
a. Position the SIMM(s) so that the notched corner of the SIMM is facing
towards the back and down into the printer.
b. Slide the SIMM straight down into the connector.
c. Rotate the SIMM downward, towards you until it “clicks” into place as
the retaining clips slip over the top of the SIMM.
Installing SIMMs into the Elite XL
Note: The SIMMs
pictured in the
illustration show
memory chips on
both sides of the
SIMM; the SIMM(s)
you are installing
may have memory
chips on only one
side.
Notch