GCC Printers Elite XL - Manual (Page 197)

L-1 License and warranties
OPENING THE BAG CONTAINING THE SOFTWARE (the “Software”) WHICH ACCOMPANIES THIS MANUAL INDICATES YOUR
ACCEPTANCE OF THE TERMS AND CONDITIONS CONTAINED IN THIS LICENSE AGREEMENT. THE TERMS OF THIS LICENSE
AGREEMENT APPLY TO YOU AS THE ORIGINAL LICENSEE OF THE SOFTWARE AND THE RELATED USER DOCUMENTATION
(the “Documentation”) AND TO ANY SUBSEQUENT LICENSEE THEREOF.
IF YOU DO NOT ACCEPT OR AGREE TO THE TERMS OF THIS LICENSE AGREEMENT YOU MAY RETURN THE PRODUCT, WITH
DATED PROOF-OF-PURCHASE OF THE PRODUCT, TO YOUR DEALER WITHIN 10 DAYS FOR A FULL REFUND OF PURCHASE
PRICE THEREOF. ALL RETURNED SOFTWARE MUST BE UNUSED AND IN THE UNOPENED PLASTIC BAG.
LICENSE
In return for payment of the purchase price of your GCC Technologies Product (“the Product”), you have been granted a limited, non-exclusive
license (“License”) to use the Software and the Documentation on the terms set forth in this License Agreement.
GCC Technologies, Inc. (“GCC”) retains ownership of these copies of the Software and the Documentation. These copies of the Software and the
Documentation are licensed to you according to the following terms:
PERMITTED USES
YOU MAY:
1. Use the Software with any appropriate GCC product.
2. Copy the Software onto a single hard disk drive.
3. Transfer the Software to another party, if the other party agrees to the terms and conditions of this License Agreement and completes and
returns a Registration Card to GCC. The Registration Card may be obtained by writing to GCC’s Customer Service department at the address set
forth below. If you transfer the Software to any other party, you must transfer all copies and the Documentation to such party.
4. Make a single copy of the Software on another diskette for backup purposes only.
PROHIBITED USES
THE LICENSE OF THE SOFTWARE AND THE DOCUMENTATION GRANTED TO YOU IS LIMITED, AND YOU MAY NOT:
1. Make copies of any of the Documentation or make copies of the Software other than as expressly set forth above.
2. Alter, modify or adapt the Software or the Documentation, including translating, decompiling, disassembling, creating derivative works, or
merging the Software with other software.
3. Use any backup diskette you have made or allow someone else to use any backup diskette unless the Software on the original diskette is
defective.
4. Rent, sublicense, assign or otherwise transfer any interest in any of the Software or the Documentation except as set forth above.
5. Modify or erase any copyright, trademark or proprietary rights notice on any medium containing the Software or the Documentation or copy or
reproduce any of the Software or the Documentation without all of GCC’s copyright, trademark and proprietary rights notices.
The License is effective until terminated. You may terminate it at any time by destroying all copies of the Software you have and mailing your
original Software diskettes and the Documentation to GCC. The License and your right to use the Software will automatically terminate upon
your failure to comply with any provision of this License Agreement or upon GCC’s election to terminate the License as set forth below. You
agree upon such termination to destroy all copies of the Software which you have and to mail your original Software diskettes and the Documenta-
tion to GCC.
GCC retains all rights and title to the Software and the Documentation except for the limited license contained herein. The Software and the
Documentation are protected by the copyright laws of the United States. There are severe penalties, civil and criminal, for copyright infringement.
Nothing in this License Agreement constitutes a waiver of GCC’s rights under the copyright laws of the United States or any other law.
Software License Agreement
Appendix
L
License and warranties