GCC Printers Elite XL - Manual (Page 40)

Setting up the Elite XL Chapter 1
1-26 Chapter 1
Option 2 - BNC to BNC connection
This connection option specifies a BNC (10BASE-2) connector on the
EtherTalk network card installed in the computer (Macintosh or IBM PC and
compatibles).
Items needed:
Computer with EtherTalk and BNC connector
2 BNC “T” connectors
2 50 ohm terminators
1 length (at least 6 feet long) of RG-58 coaxial cable
Elite XL 10BASE-2
connector
EtherTalk capable
computer with AAUI
port
Terminator
(see step 3)
BNC “T” connector
(see step 2)
RG-58 cable
(see steps 5,6)
AAUI to Thin Coax media
adapter/tranceiver (self-
terminating)
AAUI connector
(see step 4)