GCC Printers Elite XL - Manual (Page 179)

Appendix C Upgrading the printer’s memory
C-6 Appendix C
11. Replace the metal shield plate.
Reposition the metal shield plate then, using the Phillips screwdriver, fasten
it back down with the screw. (Refer to the illustration in step 5 for reposi-
tioning information.)
12. Replace the controller board access panel.
Reposition the controller board access panel. (Refer to the illustration in
step 4 for repositioning information.)
13. Reconnect the interface cables and the AC power cord to the back of the
printer.
14. Plug the AC power cord into the wall.
Confirming the installation
After you have completed the installation procedures, confirm that the installa-
tion was successful and that the printer recognizes the additional memory.
To confirm the installation:
1. Switch on the printer.
2. Take the printer off line .
Press the On Line key ; the display panel should now read “Off Line.”
3. Press the Menu key four times.
The display window should read “Printer Info.”
4. Press the Enter key.
The display window should read “AppleTalk Name: (name of your
printer).”
5. Press the Menu key twice.
The display window should now display the total amount of RAM installed
in the printer.
If the correct amount of RAM is not displayed, go back over the installation
procedure, making sure that the SIMMs are seated correctly. If the memory is