GCC Printers Elite XL - Manual (Page 52)

Chapter 2 The Elite XL front panel
2-10 Chapter 2
6. Emulations/PCL (continued)
Submenu Description Settings Notes
Font
Number Determines the default font
number. Range from 1 – n The font number specified must
correspond to a font available from
the location specified by the
Font Source submenu.
Pitch Determines the number of
characters per horizontal inch for
the default font. Range from 0.44 to 99.99
(in increments of 0.01). The
default is 10.00. This submenu only appears if the font
indicated by the Font Source and
Font Number submenus is scalable
and uses fixed spacing (monospaced).
Point Size Determines the point size of the
default font; point size is the
vertical height of a character
(including some white space above
and below).
Range from 4.00 to 99.75
(in increments of 0.25). The
default is 12.00. This submenu only appears if the
default font is scalable and
proportionately spaced.
Orientation Determine the default orientation
of the image on the page. Portrait or Landscape
Page Length Determines the default number of
lines on a page. Range from 5 to 256. The
default is 60 for Letter
paper. This setting may change if the
settings in the Default Size submenu
of the Paper Handling menu are set to
a value other than the factory default.
Symbol Set Determines which set of character
symbols the default font will use. Settings include only the
character symbols the
default font supports. See page 5-4 for a list of the symbol
sets for resident PCL fonts.
Wait
Timeout Sets the amount of time the printer
waits for character input after using
all the input previously sent to the
printer. If the printer does not
receive character input within the
specified amount of time, the
printer automatically terminates
the print job. Range from 45 seconds to
120 seconds (in 15-second
increments) and Never
timeout. Some applications may change this
setting during printing. In some cases
the change will be permanent and the
new timeout setting will appear in
the display. (You may reset it or, if
the application is one you use
frequently, leave the new setting.)
Line Wrap For “plain text” print jobs,
determines if the text at the end of
a line will wrap and continue onto
the next line; or if the text will be
cut off. Disabled and Enabled
Line
Termination For “plain text” print jobs, enables
you to set carriage return and the
line feed commands (form feed) to
determine the end-of-line
indicator. Normal, CR=CRLF,
LF=CRLF & FF=CRFF,
and ALL