GCC Printers Elite XL - Manual (Page 98)

Using the Elite XL with Windows and DOS 4-19
13. Click Configure Port …. (For local printer only.)
A configuration window, specific to the type of port chosen (LPT or
COM), will appear.
GCC recommends that you use the settings shown above.
GCC recommends the above settings.
Note: The serial port settings in the printer’s front panel menus must match the settings
in this dialog box. Check the settings and change them if necessary (see Chapter 2 in
your manual). Note that the serial port’s Baud Rate submenu corresponds to the Bits per
second drop-down list box in the dialog box, while the DTR setting in the Flow Control
submenu corresponds to the Hardware setting shown above.
Installing Windows 95 printing software
LPT port configuration
dialog box
COM port configuration
dialog box