Icom IC-7000 - Manual (Page 107)

98
7
VOICE RECORDER FUNCTIONS
To transmit a message using a voice recorder, record
the desired message in advance as described below.
qSelect S - 1.
wPush [F-1 VO] then [Z(
MENU / GRP
)] to select the
voice root menu.
• If the voice root menu appears, skip the pushing
[ Z(
MENU / GRP
)]. The voice starting menu can be
changed in the miscellaneous (others) set mode.
ePush [F-3 MIC] to select the voice memory
recording mode.
rPush [Y(
MENU / GRP
)] then rotate [DIAL] to adjust
the mic gain control so that the “REC LEVEL” in-
dicator reads within maximum.
• Speak into the microphone without pushing [PTT].
• Push [F-4 DEF] to select the default mic gain.
• Push [ Z(
MENU / GRP )] to exit the mic gain adjustment
condition.
tPush [F-1 ≤≥] to select the desired memory chan-
nel, then push and hold
[F-3 REC ] for 1 sec. to
start recording.
• Speak into the microphone without pushing [PTT].
• Previously recorded contents are cleared.
yPush [F-3 REC] again to stop recording.
• Recording is automatically terminated when the total
time of recorded messages, T1–T4, becomes 90 sec.
uPush [Z(
MENU / GRP
)] twice to exit the voice mem-
ory screen.
[MENU/GRP] [F-3] [F-1]
■ Recording a message for transmit
7
DRecording
DConfirming/Erasing the recorded message
• Playing the recorded contents
q Call up the voice memory recording mode as de-
scribed in steps
q to e as shown above.
wPush [F-1 ≤≥] to select the desired memory chan-
nel, then push [F-2 PLY] to start playback.
• “ ” appears.
ePush [F-2 PLY] again to stop playback, if desired.
rPush [Z(
MENU / GRP
)] twice to exit the voice mem-
ory mode
• Erasing the recoded contents
q Call up the voice memory recording mode as de-
scribed in steps
q to e as shown above.
wPush [F-1 ≤≥] to select the desired memory chan-
nel to be erased, push [F-2 PLY] to start playback.
• “ ” appears.
ePush and hold [F-4 CLR] for 1 sec. to erase the
contents.
rPush [Z(
MENU / GRP
)] twice to exit the voice mem-
ory mode.