Icom IC-7000 - Manual (Page 115)

106
8
MEMORY OPERATION
8
Select memory channels are used for select memory
scan. Select memory scan repeatedly scans the se-
lect memory channels only. This is useful to speed up
the memory scan interval. Of course, select memory
channels are also scanned during normal memory
scan.
q
Select the memory channel list as described at left.
wPush [PBT/M-ch/RIT] momentarily to select the M-
ch/RIT function, if the twin PBT is selected.
• [PBT/M-ch/RIT] indicator (Green) goes out.
eRotate [M-ch] (inner) control to select the desired
memory channel.
• All memory channels including blank channels can be
selected.
• [ Y]/[Z] on the microphone also changes the channels.
rPush [F-1 SEL] to set the memory channel as a
select memory or not.
tRepeat steps e to r to program another memory
channel as a select memory channel, if desired.
yPush [Z(
MENU / GRP
)] twice to exit the memory
channel list.
Setting select memory channels is also possible in
the memory scan indication. (p. 115)
“ß” appears for select memory channel.
Push [F-1 SEL]
[MENU/GRP] [F-1]
[PBT/M-ch/RIT] indicator
[PBT/M-ch/RIT] switch/[M-ch] (inner) control
D Setting a memory channel as a select memory
The IC-7000 has a total of 5 memory banks (99 mem-
ory channel each), A to E, are available for usage by
group, etc.
q Select the memory channel as described at p. 102.
wPush [PBT/M-ch/RIT] momentarily to select the M-
ch/RIT function, if the twin PBT is selected.
• [PBT/M-ch/RIT] indicator (Green) goes out.
eRotate [RIT] (outer) control to select the desired
memory bank.
• Memory channel list indication
q Select the memory channel list as described at left.
wPush [F-4 BNK] several times to select the desired
memory bank.
• Rotating [RIT] (outer) control also changes the bank.
ePush [Z(
MENU / GRP
)] twice to exit the memory
channel list.
Push
Bank indication
BNK
[F-4]
[MENU/GRP]
[RIT] (outer) control
Bank indication
D Selecting a memory bank