Icom IC-7000 - Manual (Page 52)

43
4
RECEIVE AND TRANSMIT
DCW reverse mode
The CW-R (CW Reverse) mode receives CW signals
on the reverse sideband like that of LSB and USB
modes.
Use when interference is near the desired signal and
you want to change the interference tone.
qPush [MODE] several times to select CW mode.
wPush [MODE] for 1 sec. to select CW or CW-R
mode.
• Check the interference tone.
• Receive audio tone response
CW-R mode (USB side) CW mode (LSB side)
BFO
600 Hz
signal
inteference signal
600 Hz
BFO
inteference
Push
for 1 sec.
[MODE]
DCW side tone function
When the transceiver is in receive condition (and the
break-in function is OFF— p. 87) you can listen to the
tone of your CW signal without actually transmitting.
This allows you to match your transmit signal exactly
to another station’s. This also convenient for CW
practice.
qWhen CW (CW-R) mode is selected, enter the
quick set mode.
• Push [AF(
SET
)] momentarily to enter the set mode
menu.
• Push [F-1 QS] to enter the quick set mode.
wPush [F-1 ≤] or [F-2 ≥] several times to select
“Side Tone Level,” then rotate [DIAL] to ad-
just the side tone level.
• Side tone level is adjusted in 1% steps (0% to 100%).
ePush [Z(
MENU / GRP
)] to exit the quick set mode.
• Push [ Z(
MENU
/
GRP
)] again to return the normal oper-
ating mode.
[DIAL] [MENU/GRP] [F-1] [F-2]
[AF]