Icom IC-7000 - Manual (Page 139)

130
13
SET MODE
13
■ Miscellaneous (others) set mode
3 Beep(Confirmation)
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration.
The volume level can be set described below.
ON
Confirmation beep ON
(default)
OFF
Confirmation beep OFF
4 Beep(Band Edge)
A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above).
The volume level can be set described below.
ON
Band edge beep ON
(default)
OFF
Band edge beep OFF
5 Beep Level
This item adjusts the volume level for (confirmation
and band edge) beep tones from 0% to 100% in 1%
steps. When beep tones are turned OFF, this setting
has no effect.
5 0 %
50% (default)
1 Monitor
This item sets the TX monitor function ON and OFF.
The monitor gain can be set described below.
ON
TX monitor function is
turned ON.
OFF
TX monitor function is
turned OFF. (default)
2 Monitor Level
This item adjusts the transmit IF signal monitor level
from 0% to 100% in 1% steps.
See p. 89 for details.
5 0 %
50% (default)
6 Beep Level Limit
This item allows you to set a maximum volume level
for (confirmation and band edge) beep tones. The
beep tones are linked to the
[AF] control until a spec-
ified volume level is reached — further rotation of the
[AF] control will not increase the volume of the beep
tones.
ON
Beep level is limited with
[AF] (default)
OFF
Beep level is linked to [AF]