Icom IC-7000 - Manual (Page 143)

134
13
SET MODE
13
■ Miscellaneous (others) set mode
(continued)
24 SPEECH S-Level
You can have frequency, mode and signal level an-
nouncement. Signal level announcement can be de-
activated if desired.
When “OFF” is selected, the signal level is not an-
nounced.
ON
Signal level announcement
(default)
OFF
No signal level
announcement
25 SPEECH [MODE] Switch
This irem selects the operating mode speech capa-
bility when
[MODE] is pushed.
When “ON” is selected, the selected operating mode
is announced at pushing
[MODE].
ON
Operating model announce-
ment with
[MODE]
OFF
No operating mode an-
nouncement with
[MODE]
(default)
26 Memopad Numbers
This item sets the number of memo pad channels
available. 5 or 10 memo pads can be set. 5
5 memo pads
(default)
10
10 memo pads
29 MAIN DIAL Auto TS
This item sets the auto tuning step function. When ro-
tating
[DIAL] rapidly, the tuning step automatically
changes several times as selected.
There are 2 type of auto tuning steps: HIGH (Fastest)
and LOW (Faster).
HIGH Auto tuning step is turned ON.
Fastest tuning step during rapid rotation
(default)
LOW Auto tuning step is turned ON.
Faster tuning step during rapid rotation
OFF Auto tuning step is turned OFF .
27 SCAN Speed
This item sets the rate at which channels or frequen-
cies are scanned during scan operations. High and
low can be selected. HIGH
Scan is faster.
(default)
LOW
Scan is slower.
28 SCAN Resume
This item sets the scan resume function ON and OFF.
“ON” : Scan resumes 10 sec. after stopping on
a signal (or 2 sec. after a signal disap-
per).
“OFF” : Scan does not resume after stopping on
a signal. For the priority watch, setting to
OFF pauses the watch until the signal
disappears and scan resumes.
ON
Scan resume function is
ON. (default)
OFF
Scan resume function is
OFF.