Icom IC-7000 - Manual (Page 62)

53
4
RECEIVE AND TRANSMIT
DRTTY reverse mode
Received characters are occasionally garbled when
the receive signal is reversed between MARK and
SPACE. This reversal can be caused by incorrect
TNC connections, settings, commands, etc.
To receive a reversed RTTY signal correctly, select
RTTY-R (RTTY reverse) mode.
qPush [MODE] several times to select RTTY mode.
wPush [MODE] for 1 sec. to select RTTY or RTTY-R
mode.
Reverse Normal
BFO
170
Hz
2125
Hz
170
Hz
2125
Hz
BFO
Mark Space
displayed freq. displayed freq.
Mark Space
[MODE]
D Twin peak filter
The twin peak filter changes the receive frequency re-
sponse by boosting 2 particular frequencies
(2125 and
2295 Hz) for better copying of desired RTTY signals.
q
P ush [MODE] momentarily to select RTTY mode.
• After RTTY mode is selected, push [MODE] for 1 sec.
to toggle between RTTY and RTTY-R modes.
wPush [AF(
SET
)] momentarily to enter the set mode
menu.
ePush [F-1 QS] to enter the quick set mode.
rPush [F-1 ≤] or [F-2 ≥] to select “Twin Peak
Filter.”
tRotate [DIAL] to select the twin peak filter function
ON or OFF.
• The received audio volume may become greater when
the twin peak filter is turned ON.
yPush [Z(
MENU / GRP
)] twice to return the normal op-
erating mode.
[DIAL] [MENU/GRP] [F-1] [F-2]
[AF]