Icom IC-7000 - Manual (Page 59)

50
4
RECEIVE AND TRANSMIT
4
DKeyer set mode (continued)
3 Rise Time
This item sets the envelop time period which the out-
put power becomes the set transmit power. • 2, 4, 6, or 8 msec. can be selected.
• Push
[F-4 DEF] for 1 sec. to select a default setting.
(default: 4 sec.)
Key action
Tx output power
• About rise time
Rise time
Tx
Rx
Set Tx power level
Time
0
4 Paddle Polarity
This item sets the paddle polarity. • Normal and reverse polarity can be selected.
• Push
[F-4 DEF] for 1 sec. to select a default setting.
(default: Normal)
5 Keyer Type
This item selects the keyer type for [KEY] connector
on the rear panel.
• ELEC-KEY, BUG-KEY and Straight key can be se-
lected.
• Push [F-4 DEF] for 1 sec. to select a default setting.
(default: ELEC-KEY)
6 MIC U/D Keyer (HM-103)
(Microphone’s
[UP]/[DN] switches keyer)
This item allows you to set the microphone
[UP]/[DN]
switches to be used as a paddle.
• ON : [UP]/[DN] switches can be used for CW.
• OFF: [UP]/[DN] switches cannot be used for CW.
• Push [F-4 DEF] for 1 sec. to select a default setting.
(default: OFF)
NOTE: When “ON” is selected, the frequency and
memory channel cannot be changed using the
[UP]/[DN] switches.
Connect a CW paddle as at right to operate an elec-
tronic keyer from [MIC] connector.
• This function is available from both of the front panel
and rear panel mic connector.
• Be sure to select “Paddle Polarity” and “Keyer Type”
in the keyer set mode. (see above)
• Connect straight key to “DOT” side.
MIC connector
MIC U/D
CW
paddle
DOT E
DASH
w
u
3.9 k1 ±5%
2.2 k1 ±5%
D Paddle operation from [MIC] connector