Icom IC-7000 - Manual (Page 112)

103
8
MEMORY OPERATION
qPush [PBT/M-ch/RIT] momentarily to select the M-
ch/RIT function, if the twin PBT is selected.
• [PBT/M-ch/RIT] indicator (Green) goes out.
wSet the desired frequency and operating mode in
VFO mode.
• If you want to program the split frequency function, pro-
gram both rec
eive and transmit frequencies into VFO
A and B, then turn ON the split function. (p. 91)
• If you want to program a repeater function, set a tone
frequency (p. 60) in addition to the receive/tr ansmit fre-
quencies.
eSelect the menu M - 2.
rPush [F-1 MEM] to display the memory channel
contents.
• Memory channel contents appear above the multi-func-
tion key indicator.
• Push [F-1 LST] to display the memory channel list.
This is convenient for selecting the desired channel.
Push
[ Z(
MENU / GRP
)] to exit the memory channel list.
tRotate [M-ch] to select the desired memory chan-
nel.
• “ ” and “---,---,--” appear if the selected memory
channel is a blank channel (and does not have con-
tents).
• Rotating [RIT] (outer) control changes the bank.
yPush [F-2 MW] for 1 sec. to program the displayed
frequency and operating mode into the selected
memory channel.
To check the programmed contents, push [F-4 V/M]
to select memory mode.
[EXAMPLE]: Programming 7.088 MHz/LSB into ch 12.
Push for
1 sec.
MW
[F-2]
[PBT/M-ch/RIT] indicator
[PBT/M-ch/RIT] switch/[M-ch] (inner) control
[MENU/GRP]
[RIT] (outer) control
■Memory programming
DProgramming in VFO mode
Memory channel programming can be performed ei-
ther in VFO mode or in memory mode.
Menu group selection
Push [MENU/GRP] for 1 sec.
Selection from: M, S or G(Graphic)
Menu selection (Example: M)
Push [MENU/GRP] momentarily.
Selection from: M - 1 , M - 2 or M - 3
Either
Y or Z
Either
Y or Z