Juniper Networks EX8208 - Manual (Page 138)

• Calculating Power Requirements for an EX8208 Switch on page 114
AC Power Cord Specifications for an EX8200 Switch
Each AC power supply has a single AC appliance inlet located on the power supply that
requires a dedicated AC power feed. Most sites distribute power through a main conduit
that leads to frame-mounted power distribution panels, one of which can be located at
the top of the rack that houses the switch. An AC power cord connects each power supply
to the power distribution panel.
Each detachable AC power cord is 2.5 meters (approximately 8 feet) long. The appliance
coupler at the female end of the cord inserts into the AC appliance inlet on the faceplate
of the AC power supply. The coupler type is C19 as described by the International
Electrotechnical Commission (IEC) standard 60320. The plug at the male end of the
power cord fits into the power source outlet that is standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 4.5 meters (approximately
15 feet) in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA
75, 5-2.2) and 210-52 and Canadian Electrical Code (CEC) Section 4-010(3). The cords
shipped with the switch are in compliance.
Table 47 on page 112 lists the AC power cord specifications for an EX8200 switch for the
countries and regions listed in the table.
Table 47: AC Power Cord Specifications for an EX8200 Switch
Plug Standards Electrical Specifications Country/Region
AS/NZS 3112 250 VAC, 15 A, 50 Hz Australia
GB 1002 250 VAC, 16 A, 50 Hz China
CEE (7) VII 250 VAC, 16 A, 50 Hz Europe (except Italy,
Switzerland, and United
Kingdom)
CEI 23-16 250 VAC, 16 A, 50 Hz Italy
NEMA 6–20
NEMA L6–20
250 VAC, 16 A, 50 Hz Japan
Copyright © 2010, Juniper Networks, Inc. 112
Complete Hardware Guide for EX8208 Ethernet Switches