Juniper Networks EX8208 - Manual (Page 57)

• 48-port SFP line card
• 48-port RJ-45 line card
You can use any combination of line cards in an EX8200 switch.
The 8-port SFP+ line card for EX8200 switches (see Figure 12 on page 31) has eight
10-gigabit SFP+ ports on the faceplate in which you can install SFP+ transceivers. The
line card is shipped with dust covers preinstalled in the ports. Each port has two LEDs.
See “Network Port LEDs in an EX8200 Switch” on page 37.
Figure 12: 8-port SFP+ Line Card
The line card has two status LEDs labeled ON and ST on the faceplate that indicate the
online and status information for the line card. See “Line Card LEDs in an EX8200 Switch”
on page 35.
Related Topics 40-port SFP+ Line Card in an EX8200 Switch on page 31 •
• 48-port SFP Line Card in an EX8200 Switch on page 33
• 48-port RJ-45 Line Card in an EX8200 Switch on page 34
• Optical Interface Support in EX8200 Switches on page 60
• SFP+ Direct Attach Cables for EX Series Switches on page 83
• Installing a Line Card in an EX8200 Switch on page 160
• Handling and Storing Line Cards in EX8200 Switches on page 227
40-port SFP+ Line Card in an EX8200 Switch
The line cards in EX8200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that can be
installed in the line card slots on the front of the switch chassis. The line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
EX8200 switches use four types of line cards:
• 8-port SFP+ line card
• 40-port SFP+ line card
31 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Component Descriptions