Juniper Networks EX8208 - Manual (Page 317)

CHAPTER 20
Power and Electrical Safety Information
• General Electrical Safety Guidelines and Warnings for EX Series Switches on page 291
• Prevention of Electrostatic Discharge Damage on EX Series Switches on page 292
• AC Power Electrical Safety Guidelines for EX Series Switches on page 294
• AC Power Disconnection Warning for EX Series Switches on page 295
• DC Power Electrical Safety Guidelines for EX Series Switches on page 296
• DC Power Disconnection Warning for EX Series Switches on page 297
• DC Power Grounding Requirements and Warning for EX Series Switches on page 298
• DC Power Wiring Sequence Warning for EX Series Switches on page 299
• DC Power Wiring Terminations Warning for EX Series Switches on page 301
• Multiple Power Supplies Disconnection Warning for EX Series Switches on page 302
• TN Power Warning for EX Series Switches on page 302
• In Case of Electrical Accident: Action to Take on an EX Series Switch on page 303
General Electrical Safety Guidelines and Warnings for EX Series Switches
WARNING: Certain ports on the switch are designed for use as intrabuilding
(within-the-building) interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE , Issue 4) and require isolation from the exposed outside plant (OSP)
cabling. To comply with NEBS requirements and protect against lightning surges and
commercial power disturbances, the intrabuilding ports must not be metallically
connected to interfaces that connect to the OSP or its wiring. The intrabuilding ports
on the switch are suitable for connection to intrabuilding or unexposed wiring or cabling
only. The addition of primary protectors is not sufficient protection for connecting these
interfaces metallically to OSP wiring.
CAUTION: Before removing or installing components of a switch, attach an ESD strap
to an ESD point and place the other end of the strap around your bare wrist. Failure to
use an ESD strap could result in damage to the switch.
291 Copyright © 2010, Juniper Networks, Inc.