Juniper Networks EX8208 - Manual (Page 45)

The maintenance mode allows you to cycle through options for configuring and
troubleshooting the switch:
• System halt
• Reboot system
• Load rescue configuration
• Revert to factory configuration
• EZSetup
LCD Panel Menus
The LCD has three menus: Idle, Status, and Maintenance. In each of these menus, line
one of the LCD panel displays the hostname of the switch. Toggle between the LCD
menus by pressing the
Menu button. Navigate through the menu options by pressing the
Enter button.
Table 7 on page 19 describes the LCD menu options.
Table 7: LCD Panel Menu Options for the EX8200 Switch
Description Menu
In the Idle menu:
• Press Enter to cycle through the Status LED modes, which are port status indicators:
• ADM (enabled/disabled)
• SPD (speed)
• DPX (duplex)
See “Network Port LEDs in an EX8200 Switch” on page 37 for information on the Status LED.
• Press Menu to exit the Idle menu and go to the Status menu.
Idle
19 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Component Descriptions