Juniper Networks EX8208 - Manual (Page 86)

Optical Interface Support in EX8200 Switches
This topic describes the optical interfaces supported for transceivers used in the SFP
and SFP+ line cards for EX8200 switches. It also lists the copper interface supported for
the SFP transceivers.
NOTE: Use only optical transceivers and optical connectors purchased from Juniper
Networks for your EX Series switch.
The Gigabit Ethernet SFP and SFP+ transceivers installed in EX8200 switches support
digital optical monitoring (DOM): you can view the diagnostic details for these transceivers
by issuing the operational mode CLI command
show interfaces diagnostics optics . The
command does not give any output for copper transceivers, Fast Ethernet transceivers,
or transceivers not purchased from Juniper Networks.
The tables in this topic describe the optical interface support over single-mode fiber-optic
(SMF) and multimode fiber-optic (MMF) cables for SFP and SFP+ transceivers and over
the copper interface for SFP transceivers:
• Table 31 on page 61—Optical interface support for SFP+ transceivers in 8-port SFP+
line cards
• Table 32 on page 66—Optical interface support for SFP transceivers in 40-port SFP+
line cards
• Table 33 on page 70—Optical interface support for SFP+ transceivers in 40-port SFP+
line cards
• Table 34 on page 75—Optical interface support and copper interface support for SFP
transceivers in 48-port SFP line cards
Copyright © 2010, Juniper Networks, Inc. 60
Complete Hardware Guide for EX8208 Ethernet Switches