Juniper Networks EX8208 - Manual (Page 60)

Figure 15: 48-port SFP Line Card
g020506
Ejector levers
Line card LEDs
Captive screw
SFP ports
The line card has two status LEDs labeled ON and ST on the faceplate that indicate the
online and status information for the line card. See “Line Card LEDs in an EX8200 Switch”
on page 35.
Related Topics 8-port SFP+ Line Card in an EX8200 Switch on page 30 •
• 40-port SFP+ Line Card in an EX8200 Switch on page 31
• 48-port RJ-45 Line Card in an EX8200 Switch on page 34
• Optical Interface Support in EX8200 Switches on page 60
• Installing a Line Card in an EX8200 Switch on page 160
• Handling and Storing Line Cards in EX8200 Switches on page 227
48-port RJ-45 Line Card in an EX8200 Switch
The line cards in EX8200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that can be
installed in the line card slots on the front of the switch chassis. The line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
EX8200 switches use four types of line cards:
• 8-port SFP+ line card
• 40-port SFP+ line card
• 48-port SFP line card
• 48-port RJ-45 line card
You can use any combination of line cards in an EX8200 switch.
The 48-port RJ-45 line card for EX8200 switches (see Figure 16 on page 35) has 48
10/100/1000 Gigabit Ethernet ports with RJ-45 connectors on the faceplate. Each port
has two LEDs. See “Network Port LEDs in an EX8200 Switch” on page 37.
Copyright © 2010, Juniper Networks, Inc. 34
Complete Hardware Guide for EX8208 Ethernet Switches