Juniper Networks EX8208 - Manual (Page 160)

Figure 41: Adjustable Mounting Brackets for Four-Post Rack Installation
6. Position the right front adjustable mounting bracket at the desired position in the
right side of the rack opposite the installed left front bracket, so that it is on the same
rack level as the left bracket. If the right and left front brackets are not on the same
level, the chassis will rest at an angle in the rack instead of resting flat and level. Line
up the right bracket's front screw holes with the holes in the rack. Use 4 mounting
screws appropriate for your rack to attach the right front bracket to the rack.
7. Position the other rear bracket at the right rear of the rack on the same level as the
right front bracket, so that the rear bracket overlaps with the right front bracket. The
screw holes for connecting the front and rear brackets should overlap. Use 4 mounting
screws appropriate for your rack to attach the rear bracket to the rack.
8. Connect the right front and rear brackets (see Figure 41 on page 134):
a. Insert 6 of the screws provided with the mounting brackets into the overlapping
bracket holes.
b. Hand tighten the screws fully (to 12–16 in.-lb torque) using a number 2 Phillips
screwdriver.
Copyright © 2010, Juniper Networks, Inc. 134
Complete Hardware Guide for EX8208 Ethernet Switches