Juniper Networks EX8208 - Manual (Page 229)

To remove the switch using a lift (see Figure 79 on page 203):
1. Use the appropriate Phillips (+) screwdriver to remove the 24 mounting screws that
attach the chassis front-mounting brackets to the rack or cabinet.
2. Move the lift to the rack and position it so that its platform is centered about 0.5 in.
(1.27 cm) below the bottom of the switch chassis and as close to it as possible.
3. Carefully slide the switch from the adjustable mounting brackets attached to the
rack onto the lift.
4. Use the lift to transport the switch to its new location.
Figure 79: Removing an EX8208 Switch Chassis Using a Mechanical Lift
Related Topics Removing an EX8208 Switch from a Rack or Cabinet Without Using a Mechanical Lift
on page 203 •
Removing an EX8208 Switch from a Rack or Cabinet Without Using a Mechanical Lift
If you cannot use a mechanical lift to remove the switch (the preferred method), you can
remove it manually.
203 Copyright © 2010, Juniper Networks, Inc.
Chapter 12: Removing the Switch