Juniper Networks EX8208 User Manual
Page 188
are not as markedly distinguishable as those of the longer ones (see Figure 59 on
page 162).
Figure 59: Closed and Open Positions of the 2-in. Ejector Lever
Open
Ejector lever
Line card
Closed
g020907
5.
Place one hand around the faceplate of the line card and the other hand under the
line card to support it.
CAUTION: The line cards in EX8200 switches weigh more than 10 lb (4.5 kg). Be
prepared to support the full weight as you slide the line card into the chassis.
Before you slide the line card into the slot on the switch chassis, ensure the line card is
aligned correctly. Misalignment might cause the pins to bend, making the line card
unusable.
6.
Lift the line card, and position it in the chassis with the faceplate facing you and the
sides of the line card aligned with the guides in the line card slot on the switch chassis.
7.
Make sure the levers stay in the open position (see Figure 59 on page 162) and gently
slide the line card fully into the slot using both hands.
NOTE: You might need to lift the line card slightly to seat it correctly in the slot.
8.
Grasp the ejector levers on the line card and push them inward simultaneously until
the line card is fully seated (see Figure 60 on page 162 and Figure 61 on page 163).
Figure 60: Installing a Line Card with a 2-in. Ejector Lever
g020905
Ejector
levers
Captive
screw
EX8200-40XS
Copyright © 2010, Juniper Networks, Inc.
162
Complete Hardware Guide for EX8208 Ethernet Switches