Juniper Networks EX8208 - Manual (Page 72)

Table 24: N+N Power Supply Requirements for EX8216 Switch
Configurations Using 3000 W AC Power Supplies (Junos OS Release 10.2
or Later Only)
Power Supplies
Needed for N+N Power Supplies
Needed (N)
Input Voltage
Switch
Configuration
2 1 High-voltage line
(200–240 VAC) Base
6 3 High-voltage line
(200–240 VAC) Fully loaded with
8-port SFP+ line
cards
Related Topics AC Power Specifications for EX8200 Switches on page 109 •
• AC Power Supply LEDs in an EX8200 Switch on page 46
• Calculating Power Requirements for an EX8208 Switch on page 114
• Calculating Power Requirements for an EX8216 Switch
• Installing an AC Power Supply in an EX8200 Switch on page 150
• Removing an AC Power Supply from an EX8200 Switch on page 207
AC Power Supply LEDs in an EX8200 Switch
An AC power supply has three LEDs on its faceplate. These LEDs display information
about the status of the power supply. See Figure 27 on page 46.
Figure 27: AC Power Supply LEDs on an EX8200 Switch
Table 25 on page 47 describes the LEDs on an AC power supply in an EX8200 switch.
Copyright © 2010, Juniper Networks, Inc. 46
Complete Hardware Guide for EX8208 Ethernet Switches