Juniper Networks EX8208 - Manual (Page 215)

CHAPTER 11
Performing Initial Configuration
• EX8200 Switch Default Configuration on page 189
• Connecting and Configuring an EX Series Switch (CLI Procedure) on page 190
• Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 192
EX8200 Switch Default Configuration
Each EX8200 switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as the ARP aging timer, the
system log, and file messages, while also enabling the LLDP protocol, the RSTP protocol,
IGMP snooping, and storm control.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. See Reverting to the Default Factory Configuration for the EX Series Switch.
This topic shows the factory default configuration file of an EX8200 switch:
system {
arp {
aging-timer 5
}
}
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
}
}
commit {
factory-settings {
reset-chassis-lcd-menu;
}
}
189 Copyright © 2010, Juniper Networks, Inc.