Sun Microsystems Sun Fire V880 - Manual (Page 107)

Maintaining disk drives
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006 107
13. Holding the drive by its handle, fit the drive into the guide rails at the top and bottom of the
drive bay. See the following figure.
14. Slide the drive into the bay until it barely contacts the backplane.
15. Press carefully on the center of the drive. The drive handle begins to close as the drive
engages its backplane connector.
16. Press the handle toward the drive until the latch closes, securing the drive in place.
17. Repeat this procedure for both boot disk drives.
18. Close the front door and, if necessary, lock it.
19. Turn on any external SCSI devices, starting with the device that is farthest from the system
and working toward the system.
20. Turn on the system monitor.
21. Turn on the system. Do not put the key switch in the locked position.
As the system powers up, the power LED on the monitor flashes.
22. Press Stop+A simultaneously as soon as the monitor power LED lights steadily and the
Sun logo is displayed on the monitor.
The ok prompt is displayed.