Sun Microsystems Sun Fire V880 - Manual (Page 91)

Maintaining PCI cards
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006 91
24. Enter:
boot -r
This reboots the system so that it recognizes the new HSI/P cards.
Note:
Note:
Sometimes the system fails to recognize a newly installed HSI card. If this
happens, the command show-devs does not show the HSI card and /var/
adm/messages fails to recognize the card upon bootup. See the troubleshooting
chapter of Avaya Call Management System Switch Connections, Administration,
and Troubleshooting for information about troubleshooting HSI/P cards.
25. When the system comes back up, log in as root.
26. Enter:
cfgadm
This displays the PCI card configuration after you add the card. Make sure that the new
card is displayed.
27. Continue with Installing HSI/P software and patches on page 91.
Installing HSI/P software and patches
Use the following procedures in the CMS software installation, maintenance, and
troubleshooting document to:
●
Install the HSI/P software
●
Reinstall the Solaris patches
After installing the software and patches, continue with Setting up the switch link for each
ACD on page 91
Setting up the switch link for each ACD
To change the switch link administration for each ACD:
1. Enter:
cmssvc
The CMS Services menu is displayed.
2. Select the run_cms option.
3. Turn off CMS.
4. Enter:
cmssvc
The CMS Services menu is displayed.
5. Select the swsetup option.