Sun Microsystems Sun Fire V880 - Manual (Page 196)

Troubleshooting
196 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
Probe command warnings
Symptom: When running any of the probe commands, the following message is displayed:
CAUTION: !
CAUTION:
Do not continue. Answer n. Do not answer y.
Solution: To recover from this condition:
1. Enter: n
This stops the probe command.
2. Enter the following commands:
setenv auto-boot? false
reset-all
3. It is now safe to run any of the probe commands and perform any other boot PROM-level
diagnostics.
4. After you finish probing the system devices, enter the following commands:
CAUTION: !
CAUTION:
If you fail to enter these commands, any reboots that you do in the future will stop
at the boot prompt instead of proceeding through the normal boot-up process.
setenv auto-boot? true
boot -r
The system reboots.
This command may hang the system if a Stop-A or halt command has been executed. Please
type reset-all to reset the system before executing this command. Do you wish to
continue [Y/N].