Sun Microsystems Sun Fire V880 - Manual (Page 95)

Maintaining PCI cards
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006 95
14. Insert the HSI/P card into slot 4 on the I/O board. Make sure that the card is fully seated.
See the following figure.
15. Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps into
place.
16. Remove the ESD wrist strap.
17. Close the left door.
18. Attach the HSI/P quad cable, and connect the switch links to the quad cable by following
the instructions described in Avaya Call Management System Switch Connections,
Administration, and Troubleshooting.
19. Turn on any external SCSI devices, starting with the device that is farthest from the system
and working toward the system.
20. Turn on the system monitor.
21. Turn on the system.
22. When the system comes back up, log in as root.
23. Enter:
cfgadm
This displays the PCI card configuration after you add the card. Make sure that the new
card is displayed.
24. Administer the switch links as shown in Setting up the switch link for each ACD on
page 91.