Sun Microsystems Sun Fire V880 - Manual (Page 43)

Turning on the system and verifying POST
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006 43
11. Enter:
probe-ide
This verifies that the system sees the DVD drive (IDE model in V890). A message that is
similar to the following example is displayed:
12. Verify that the DVD is recognized. If it is not recognized, see Troubleshooting disk drives
and DVD drives on page 186 for more information.
13. When you have verified that the system recognizes all its devices, enter the following
commands:
CAUTION: !
CAUTION:
If you fail to reset the auto-boot option, any reboots that you do in the future will
stop at the boot prompt instead of proceeding through the normal boot-up
process.
setenv auto-boot? true
boot
The system reboots.
14. Turn the key switch to the Locked position. Keeping the switch in the Locked position
prevents anyone from accidentally turning off the system. See the following figure.
Device 0 ( Primary Master )
Removeable ATAPI Model: TOSHIBA DVD-ROM SD-M1712
Device 1 ( Primary Slave )
Not Present