Sun Microsystems Sun Fire V880 - Manual (Page 199)

Recovery procedures
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006 199
4. Add @0,0 at the end of the line as shown in the following example:
nvalias disk /pci@8,600000/SUNW,qlc@2/fp@0,0/disk@0,0
Adding the @0,0 gives the command the target and slice of the primary boot device.
5. If needed, repeat the above procedure for the boot drive on a mirrored system using
bootdevice2 as your mirror boot device alias, as shown in the following example:
nvalias bootdevice2 /pci@8,600000/SUNW,qlc@2/fp@0,0/disk@3,0
Adding the @3,0 gives the command the target and slice of the mirror boot device.
6. Enter:
devalias
The device aliases are displayed. Verify that disk and bootdevice2 are set to the
correct alias values.
7. Enter:
setenv boot-device disk bootdevice2
8. Enter:
reset-all
The system resets and boots up to the operating system.
9. After setting the disk device alias, check the EEPROM values as described in "Displaying
and setting the EEPROM parameters" of the CMS software installation, maintenance, and
troubleshooting document for your CMS release. Reset any values that do not match the
values described in that section.