Probing all scsi media devices – Sun Microsystems Sun Fire V880 User Manual
Page 169
Tools
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
May 2006
169
Probing all SCSI media devices
This test checks all media devices.
Symptom: The tape, DVD, or external disk drives are reporting errors.
Solution: To check the status of the media devices:
1. Enter:
/usr/sbin/shutdown -y -i0 -g0
to shut down the system.
2. At the ok prompt, enter the following commands:
setenv auto-boot? false
reset-all
The system resets.
3. Enter:
probe-scsi-all
The program displays a message that is similar to the following:
Note:
Note:
The actual devices that are listed depends on the devices that are installed in the
system. This example shows six disk drives, the disk backplane, the tape drive
(target 5), and the DVD drive (target 6).
4. Fix any obvious errors, such as disconnected cables or external drives without power.
/pci@8,600000/SUNW,qlc@2
LiD HA LUN
--- Port WWN ---
-----Disk description -----
0
0
0
21000004cf72f08f
SEAGATE ST373405FSUN3660438
1
1
0
21000004cf721553
SEAGATE ST373405FSUN3660438
2
2
0
21000004cf7213ea
SEAGATE ST373405FSUN3660438
6
6
0
508002000016b5b1
SUNW
SUNWGS INT FCBPL9224
3
3
0
21000004cf72114b
SEAGATE ST373405FSUN3660438
4
4
0
21000004cf7211ae
SEAGATE ST373405FSUN3660438
5
5
0
21000004cf7214a3
SEAGATE ST373405FSUN3660438
/pci@8,700000/scsi@1
Target 5
Unit 0
Removeable Tape
HP
C5683A
C005
Target 6
Unit 0
Removeable Read Only device
TOSHIBA DVD-ROM SD-M14011009
/pci@8,700000/pci@5/SUNW,1sptwo@4