Sun Microsystems Sun Fire V880 - Manual (Page 146)

Maintenance
146 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
4. Loosen the two captive Phillips screws securing the power supply to the system rear
panel. See the following figure.
5. Pull the power supply out from its bay. Use one hand to pull the power supply out while
using the other hand to support the power supply as it is removed from the system.
!
Important:
Important:
When hot-swapping a power supply, do not disengage and reengage the supply
in rapid succession. Rapid seating and unseating of power supplies will result in
false error conditions.
6. After removing a supply, wait for an acknowledgement message on the system console
before installing a new supply. Otherwise, the environmental monitoring software will not
recognize the new device, and false error conditions will result.