Sun Microsystems Sun Fire V880 - Manual (Page 142)

Maintenance
142 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
6. Make sure that the ejection levers on the CPU/Memory board are pointed out, rotated at
90 degrees. See the following figure.
7. Slide the CPU/Memory board into the guides in the chassis. Slide the board into the
system until the connectors on the board begin to engage the sockets on the motherboard
and the ejection levers begin to contact the bracket.
8. Push in the two ejection levers simultaneously until the board is fully engaged in its slot.
9. Hand-tighten the two captive screws on the CPU/Memory board.
10. Using a No. 2 Phillips screwdriver, fully tighten the right captive screw and repeat for the
left captive screw.
11. Remove the ESD wrist strap.
12. Close the side door.