Sun Microsystems Sun Fire V880 - Manual (Page 77)

Maintaining PCI cards
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006 77
12. Insert the new graphics card into the slot on the I/O board. Make sure that the card is fully
seated. See the following figure.
13. Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps into
place.
14. Connect the monitor cable to the card.
15. Remove the ESD wrist strap.
16. Close the left door.
17. Reattach the monitor cable.
18. Turn on any external SCSI devices, starting with the device that is farthest from the system
and working toward the system.
19. Turn on the system monitor.
20. Turn on the system.
21. When the system comes back up, log in as root.
22. Enter:
cfgadm
This displays the PCI card configuration after you replace the card. Make sure that the new
card is displayed.