Sun Microsystems Sun Fire V880 - Manual (Page 170)

Troubleshooting
170 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
5. When you finish testing, enter the following commands:
CAUTION: !
CAUTION:
If you fail to enter these commands, any reboots that you do in the future will stop
at the boot prompt instead of proceeding through the normal boot-up process.
setenv auto-boot? true
boot -r
The system reboots.
Probing the IDE DVD device (V890 only)
This test checks the DVD drive on the V890.
Symptom: The DVD is reporting errors.
Solution: To check the status of the DVD device:
1. Enter:
/usr/sbin/shutdown -y -i0 -g0
to shut down the system.
2. At the ok prompt, enter the following commands:
setenv auto-boot? false
reset-all
The system resets.
3. Enter:
probe-ide
The program displays a message that is similar to the following:
4. Fix any obvious errors, such as disconnected cables or external drives without power.
Device 0 ( Primary Master )
Removeable ATAPI Model: TOSHIBA DVD-ROM SD-M1712
Device 1 ( Primary Slave )
Not Present