Sun Microsystems Sun Fire V880 - Manual (Page 127)

Maintaining tape drives
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006 127
8. Remove the two screws securing the front cover to the front of the system. See the
following figure.
9. Remove the front cover.
10. Disconnect the data and power cables from the back of the drive.
11. Remove the two screws that secure the drive to the chassis.
12. Slide the drive out through the front of the chassis.
13. Set the SCSI address on the new drive using the jumpers on the back of the drive. Set the
tape drive to 5. See the following figure.
14. Slide the replacement drive into the chassis and secure it with the screws that you
removed earlier.
8 4 2 1
tape_jumpers.cdr
TP NC 8 4 2 1
DDS-4 DAT 72