Sun Microsystems Sun Fire V880 - Manual (Page 47)

Setting the remote console modem options
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006 47
7. Enter the following commands:
AT
AT&F1 (loads the factory default configuration into active memory)
AT&W0 (writes the current configuration to NVRAM template Y0)
Note:
Note:
Use numerical ones and zeros when entering the options.
8. After you enter the options, disconnect from the modem by entering a tilde and a period
(~.).
The following message is displayed:
9. Set DIP switches 4 and 8 on the back panel of the Sportster modem to the down (ON)
position. Set all other DIP switches to the up (OFF) position.
10. Reset the modem by turning the power off and back on.
11. Enter:
/cms/install/bin/abcadm -i -b 9600 ttya
The following message is displayed:
12. Verify that the AA (auto-answer), TR (terminal ready), and CS (clear-to-send) LEDS are lit
on the modem.
13. Have the provisioning team dial in to the modem for testing.
Additional references: For additional information, see the U.S. Robotics Sportster Modems
Users Guide.
Disconnected
ttya set to incoming port 9600 baud