National Instruments FP-3000 - Manual (Page 111)

Appendix C FP-3000 Specific Parameters
© National Instruments Corporation C-9 FieldPoint FP-3000 User Manual
LAST_RUN_ERROR
The last run error detected by the block (used for debugging).
LO_LO_OUT_D
Discrete output indicating state of Lo-Lo alarm condition.
LO_OUT_D
Discrete output indicating state of Lo alarm condition.
LTYPE_DOMAIN_INDEX
Virtual field device index of the domain associated with expression in this
AI block.
NVM_LIFE
Remaining useful life of non-volatile memory (NVM).
Table C-7. Block Events
Event Description
CLASS The type of event detected.
Configuration Error: An error has been detected in the
configuration of the block.This is usually due to an uninitialized static
parameter. The block updates its
TARGET mode to Out of Service
and posts a block alarm.
Operational Warning: The block detected a non-critical event.
The block continues to execute normally.
Operational Error: The block detected a critical event. The block
continues to execute in a higher priority mode.
Internal Error: The firmware detected an internal error.
MSG A message containing specific details describing the event.
BLOCK_IDX The index of the block causing the event.
PARAM_IDX The index of the parameter causing the event.
TARGET_MODE The TARGET mode of the block when the event was detected.
ACTUAL_MODE The ACTUAL mode of the block when the event was detected.
TIME_STAMP Time when the error was detected.