National Instruments FP-3000 User Manual
Page 154
Index
FieldPoint FP-3000 User Manual
Index-12
© National Instruments Corporation
software configuration problems, F-4 to F-7
generic software configuration problems
(table), F-4 to F-6
overview, F-4
resource block configuration problems
(table), F-7
using third-party configuration
software, 1-5
SP parameter, B-21
SP_D parameter, B-21
SP_HI_LIM parameter, B-21
SP_LO_LIM parameter, B-21
SP_RATE_DN parameter, B-21
SP_RATE_UP parameter, B-21
specifications
compliance, E-1
environment, E-1
network, E-1
STAT (FieldPoint Statistics Block) function
block, 4-4
status and mode behavior during cascade
initialization, D-2 to D-3
status calculation rules, for Expression
block, 4-6
status handling, 4-21 to 4-22
Limit subfield values (table), 4-22
Quality subfields (table), 4-21
Substatus field, 4-22
STATUS LED
description of LED states
(table), 2-15 to 2-16
flashes and error conditions (table), 2-15
operation, 2-14
STATUS_OPTS parameter (table), B-22
STRATEGY parameter, B-23
ST_REV parameter, B-21
Subcode alarm parameter, 4-20
Substatus field, 4-22
SUPPORTED_MODES parameter, C-10
system integration, by National
Instruments, G-1
T
TAG_DESC parameter, B-23
tags
assigning address and device tag at initial
power on, 3-1 to 3-2
assigning tag to new block
converting pressure sensor to
Fieldbus (example), 3-3
temperature control with FP-3000
(example), 3-8, 3-11, 3-13
setting device tag and network
address, F-1
TARGET mode, 4-22, B-14
technical support resources, G-1 to G-2
temperature control with FP-3000
(example), 3-7 to 3-17
alarm setting, 3-17
controlling heating element, 3-11 to 3-13
assigning tag to new block, 3-11
bringing block online, 3-12 to 3-13
scaling output, 3-12
selecting module and channel, 3-11
setting output range, 3-11
getting started, 3-7
PID control, 3-13 to 3-17
assigning tag to new block, 3-13
connecting PID to AI and AO
blocks, 3-14 to 3-15
downloading and bringing loop into
Auto, 3-16
scaling the PID, 3-14
tuning the PID, 3-16 to 3-17
taking temperature readings, 3-8 to 3-10
assigning tag to new block, 3-8
bring block online, 3-10
creating FP-TC-120 block, 3-8
scaling the reading, 3-9 to 3-10
selecting module and channel, 3-8
setting input range and thermocouple
type, 3-9