National Instruments FP-3000 User Manual
Page 153
Index
© National Instruments Corporation
Index-11
FieldPoint FP-3000 User Manual
bringing block online, 3-6
creating FP-AI-110 block, 3-3
scaling the reading, 3-4 to 3-5
selecting module and channel, 3-3 to 3-4
setting input range, 3-4
setting up scheduling, 3-5 to 3-6
problem solving. See troubleshooting.
PROCESS LED, 2-15
program constructs, in Expression
block, 4-7 to 4-14
Proportional-Integral-Derivative function
block. See PID control; PID
(Proportional-Integral-Derivative) function
block.
PV parameter, B-16
PV_D parameter, B-17
PV_FTIME parameter, B-17
PV_SCALE parameter, B-17
PV_STATE parameter, B-17
Q
Quality subfields for status handling
(table), 4-21
questions and answers. See troubleshooting.
R
RA_FTIME parameter, B-17
RATE parameter, B-17
RCAS_IN parameter, B-17
RCAS_IN_D parameter, B-18
RCAS_OUT parameter, B-18
RCAS_OUT_D parameter, B-18
READBACK parameter, B-18
READBACK_D parameter, B-18
READY LED, 2-14
Remote Cascade mode (table), 4-24, B-15
remote cascades, D-3
Remote Output mode (table), 4-24, B-15
reserved symbols, in Expression
block, 4-7 to 4-8
RESET parameter, B-18
Reset switch, A-2
resource block
configuration problems (table), F-7
description, 4-3
RESTART parameter (table), B-18 to B-19
ROUT_IN parameter, B-19
ROUT_OUT parameter, B-19
RS_STATE parameter (table), B-19
RUN_STATUS parameter, C-10
RUN_TIME parameter, C-10
S
SAFEGUARD_CL parameter, C-10
SAFEGUARD_OP parameter, C-10
Safety Isolation, 2-11
scaling the reading
converting 4-20 mA pressure sensor to
Fieldbus (example), 3-4 to 3-5
temperature control with FP-3000
(example), 3-9 to 3-10
scheduling
allowing unscheduled time, F-10
converting 4-20 mA pressure sensor to
Fieldbus (example), 3-5 to 3-6
SEL_1 through SEL_3 parameter, B-19
SEL_TYPE parameter, B-19
SET_FSTATE parameter, B-20
set_status function (table), 4-13
SHED_OPT parameter (table), B-20
SHED_RCAS parameter, B-20
SHED_ROUT parameter, B-20
Simulate Enable switch, A-1
SIMULATE parameter, B-20
SIMULATE_D parameter, B-21