National Instruments FP-3000 - Manual (Page 77)

© National Instruments Corporation A-1 FieldPoint FP-3000 User Manual
A
Configuring the FP-3000
The FP-3000 has three configuration switches accessible from an opening
in the top of the module. These switches are shown in Figure A-1.
Figure A-1. Configuration Toggle Switches
Simulate Enable
When On, this switch allows simulation on I/O blocks to be enabled. The
status of this jumper is shown in the Simulate Active bit in the resource
block’s
BLOCK_ERR parameter. If the switch is On, the bit is set, and the
device allows simulation to be enabled on I/O blocks.
Reset
Switch
Write
Lock
Switch
Off
On
Simulate
Enable
Switch