Nortel Networks M3110 - Manual (Page 114)

Page 114 of 504 M2016S Secure Set
553-3001-367 Standard 3.00 August 2005
If a telephone must be returned to the factory, pack it in the appropriate
container to avoid damage during transit. Remember to include all loose parts
(cords, handset, power unit, labels, and lenses) in the shipment.
Installation and removal of M2016S Secure Set
Follow the steps in Procedure 24 on page 114 to install the M2016S.
Procedure 24
Installing the M2016S telephone
1 Complete the wiring and cross-connections (loop power) before
connecting the telephone to the TELADAPT connector. See Figure 22 on
page 115 and Figure 23 on page 116 .
2 Place the telephone upside down on a number of sheets of soft, clean
paper on a solid, level work surface to prevent damage to movable keys
and the telephone’s face.
3 Connect the handset cord (5-conductor TELADAPT connectors) to the
handset and snap it into place.
4 Connect the other end of the handset cord to the connector in the bottom
cover of the telephone. Turn the smooth side of the handset cord up
(away from the telephone bottom cover) before tucking it under the
restraining tab to ensure that the telephone will sit level on the desk after
installation is complete.
5 Connect the line cord to the telephone bottom cover. Route the cord
through the channels.
6 Turn the telephone right-side up and place it in the normal operating
position.
7 Print the directory number on the designation card. Using a paper clip,
remove the number lens from the telephone. Insert the designation card
and snap the lens back into place.
8 Designate the feature keys.
9 Insert the line cord TELADAPT connector into the connecting block (jack)
and snap it into place.
10 Perform the self-test (see Procedure 25 on page 116 ) and acceptance
test procedures. See LD 31 in the Software Input/Output: Administration
(553-3001-311).