Nortel Networks M3110 - Manual (Page 432)

Page 432 of 504 Appendix C: Meridian Modular Telephones add-on modules installation
553-3001-367 Standard 3.00 August 2005
Wall mounting
The M2006, M2008, M2616, and M2016S telephones are equipped with a
reversible footstand that allows for wall mounting. The wall-mount clip
should be purchased and inserted in the handset well to hold the handset
securely in place on wall-mounted telephones. Meridian Modular Telephones
can be hung on the wall with an installed display or Key Expansion Module.
Note: The footstand cannot be reversed when the Meridian
Programmable Data Adapter or Meridian Communications Adapter is
equipped, so telephones with data cannot be wall mounted. Additionally,
some wall plates are too deep to allow for wall mounting on top of the
plate. In these cases, mount the telephone on the wall next to the plate.
An additional clip is provided for wall mounting the telephone. This clip is
attached to the switchhook rest to prevent the handset from slipping when
mounted on the wall.
Procedure 80
Wall mounting instructions for Meridian Modular Telephones
1 Remove the handset and place the telephone upside down on top of a
level, solid work surface covered with soft material or paper to prevent
damage to movable keys and the telephone face.
2 Disconnect all cords from the telephone.
3 Remove the two screws from the footstand assembly and unsnap the
footstand assembly by pressing inward at the back of footstand where it
meets the base, and pulling upward.
4 Rotate the footstand 180° and snap the footstand back into place on the
telephone bottom cover. Make sure the footstand is firmly seated on the
base of the telephone.
5 Tighten all screws and replace all cords.
6 Insert the wall-mounting clip in the switchhook rest.
7 Mount the telephone on the wall using the wall-mount holes provided on
the bottom of the footstand.
End of Procedure