Nortel Networks M3110 - Manual (Page 61)

Attendant consoles Page 61 of 504
Telephones and Consoles Description, Installation, and Operation
5 Add a line circuit for the attendant console, if not already done. Refer to
Circuit Card: Description and Installation (553-3001-211).
6 Cross-connect the attendant console at the cross-connect terminal. See
Procedure 12 on
page 69 .
7 Enter the related attendant console data in the system. Refer to Software
Input/Output: Administration (553-3001-311).
8 Test the console features using the attendant console user guide.
Note: Refer to Circuit Card: Description and Installation (553-3001-211)
for circuit card installation procedures.
End of Procedure
Removing the M2250 attendant console
Follow the steps in Procedure 7 if it is necessary to remove an M2250
attendant console.
Procedure 7
Removing the M2250 attendant console
1 Remove related attendant console data from the system memory. Refer
to the Software Input/Output: Administration (553-3001-311).
2 Locate and remove cross-connections from the attendant console cable
at the cross-connect terminal. See Procedure 12 on
page 69 .
3 Remove the circuit card if required. Refer to Circuit Card: Description and
Installation (553-3001-211).
Note: Do not remove the circuit card if any of the remaining units on the
card are assigned.
4 Disconnect the Amphenol connector on the end of the cable leading to the
cross-connect terminal from the connector on the cable leading to the
attendant console.
5 Pack the attendant console, handset, and cords in a suitable container.
End of Procedure