Nortel Networks M3110 - Manual (Page 198)

Page 198 of 504 M3900 installation and configuration
553-3001-367 Standard 3.00 August 2005
5 Enter a:\setup (assuming that drive “a” is your floppy disk drive).
6 Click on OK. The Nortel logo screen appears while the installation utility
loads.
7 The Welcome screen appears. Click Next to continue installation.
8 If you agree to the terms of the Software License Agreement, click Yes.
9 Continue to click Next until the installation is complete.
10 When asked to, remove the disk from your floppy disk drive.
11 Click Finish.
Note: You must restart your PC to access the Personal Directory PC
Utility.
12 To select a port for the Personal Directory PC Utility; click Phone. Click
Set port. The pull-down menu shows available PC ports:
• Com1
• Com2
Note: The program selects the same port each time until you change it.
Installing the Key-Based Accessory Module
The Key-Based Accessory (KBA) module provides 22 additional line/feature
keys for the M3904 and M3905 Digital Telephones. You can add up to two
KBAs, providing a total of 75 line/feature keys.
Use Procedure 36 to install the KBA.
Procedure 36
Installing the KBA
1 While depressing the telephone tilt handle, pull the telephone away from
the footstand until it clears the final stop. Gently pull the footstand off the
clips.
Note: If an ACM is installed, unplug the ACM and remove it from the
footstand. Install the ACM in the Single KBA Footstand Assembly.
2 Place the telephone and the KBA face down on a padded, level surface,
and align them.