Nortel Networks M3110 - Manual (Page 480)

Page 480 of 504 Appendix E: M3110, M3310, and M3820 telephones
553-3001-367 Standard 3.00 August 2005
Installation
Procedure 81
Installing Meridian European digital telephones
Follow this procedure to install the Meridian European digital telephones:
1 Complete the wiring and cross-connections (loop power) before
connecting the telephone to the connecting block.
2 Place the telephone on the desk in the normal operating position.
3 Place the Rls and Hold key caps on their positions just above the dialpad,
with the Hold key closest to the handset.
4 Print the directory number on the designation card. Remove the number
lens from its position underneath the handset, insert the designation card
and snap the lens into place.
5 Print the feature keys on the label strip. Remove the label lens (beside the
feature keys), insert the label strip and snap the lens into place.
6 Plug the line cord connector into the connecting block.
7 Perform the self test and acceptance procedures for Meridian Modular
telephones (see “Meridian Modular Telephones self-test” on
page 358 .
8 Supply the user with a quick reference card.
End of Procedure
Installing hardware options
This section describes procedures for installing the following options:
• Power Board on all models.
• Headset on M3310 and M3820 telephones.
• Wallmount/Desktop Position change.
For installation of other options (MCA data option, external alerter and key
expansion modules) see the section on Add-on modules for Meridian
Modular Telephones (NT2K models) in Appendix C: “Meridian Modular
Telephones add-on modules installation” on
page 371 .